Avaya Communication Manager Administrator's Manual page 123

2. In the Station Firmware Download Access Code field, enter a valid FAC as defined in the
dial plan.
3. Press Enter to save your changes.
4. Take the 2410 or 2420 DCP telephone off-hook.
5. Dial the Station Firmware Download FAC (for instance, *36).
6. Press # if you are dialing from the target station (or dial the telephone's extension to be
downloaded).
7. Place the telephone on-hook within 4 seconds after the confirmation tone.
The telephone is placed in a busy-out state (not able to make or receive calls) and displays
Firmware Download in Progress, the amount of the file downloaded, and a timer. The
telephone displays error messages and a success message before rebooting.
8. When the download completes, the telephone reboots and is released from the busy-out
state.
Downloading firmware to multiple stations
You can download firmware to multiple stations of the same type, either 2410 or 2420 DCP
telephones. Download firmware to as many as 1000 stations per download schedule. You can
schedule a specific time for the download, or you can administer the download to run
immediately.
To download 2420 DCP station firmware to multiple stations:
1. Type change firmware station-download. Press Enter.
The Firmware Station Download screen appears.
Figure 41: Firmware Station Download screen
change firmware station-download
Source File:
Schedule Download? y
Start Date/Time:/: Stop Date/Time:/:
Continue Daily Until Completed? y
Download Set Type: 2420
Beginning Station: Ending Station:
2. In the Source File field, enter the name of the file specified in the File to Retrieve field on
the TFTP Server Configuration screen.
FIRMWARE STATION DOWNLOAD
Setting up Remote Office
Issue 2.1 May 2006 123