Bdm Address Attribute Register (Baar); Address Attribute Trigger Register (Aatr) - Freescale Semiconductor ColdFire MCF52210 ColdFire MCF52211 ColdFire MCF52212 ColdFire MCF52213 Reference Manual

Debug Module
Field
4 Single-Step Mode. Setting SSM puts the processor in single-step mode.
SSM 0 Normal mode.
1 Single-step mode. The processor halts after execution of each instruction. While halted, any BDM command
can be executed. On receipt of the
This process continues until SSM is cleared.
3–0 Reserved, must be cleared.
28.4.3

BDM Address Attribute Register (BAAR)

The BAAR register defines the address space for memory-referencing BDM commands. BAAR[R, SZ]
are loaded directly from the BDM command, while the low-order 5 bits can be programmed from the
external development system. To maintain compatibility with revision A, BAAR is loaded any time the
AATR is written. The BAAR is initialized to a value of 0x05, setting supervisor data as the default address
space.
DRc[4:0]: 0x05 (BAAR)
7
R
W R
Reset: 0
Field
7 Read/Write.
R 0 Write
1 Read
6–5 Size.
SZ 00 Longword
01 Byte
10 Word
11 Reserved
4–3 Transfer Type. See the TT definition in the AATR description,
TT (AATR)".
2–0 Transfer Modifier. See the TM definition in the AATR description,
TM (AATR)".
28.4.4

Address Attribute Trigger Register (AATR)

The AATR defines address attributes and a mask to be matched in the trigger. The register value is
compared with address attribute signals from the processor's local high-speed bus, as defined by the
MCF52211 ColdFire® Integrated Microcontroller Reference Manual, Rev. 2
28-10
Table 28-6. CSR Field Descriptions (continued)
command, the processor executes the next instruction and halts again.
GO
6 5
SZ
0 0
Figure 28-4. BDM Address Attribute Register (BAAR)
Table 28-7. BAAR Field Descriptions
Description
4 3
TT
0 0
Description
Section 28.4.4, "Address Attribute Trigger Register
Section 28.4.4, "Address Attribute Trigger Register
Access: Supervisor write-only
BDM write-only
2 1 0
TM
1 0 1
Freescale Semiconductor