External Interrupt Signals; Queued Serial Peripheral Interface (Qspi) - Freescale Semiconductor ColdFire MCF52210 ColdFire MCF52211 ColdFire MCF52212 ColdFire MCF52213 Reference Manual

CLKMOD[1:0]
00
00
01
10
10
11
2.7

External Interrupt Signals

Table 2-6 describes the external interrupt signals.
Signal Name
External Interrupts
2.8

Queued Serial Peripheral Interface (QSPI)

Table 2-7 describes the QSPI signals.
Signal Name
QSPI Synchronous
Serial Output
QSPI Synchronous
Serial Data Input
QSPI Serial Clock
Synchronous Peripheral
Chip Selects
MCF52211 ColdFire® Integrated Microcontroller Reference Manual, Rev. 2
Freescale Semiconductor
Table 2-5. Clocking Modes
XTAL
0 PLL disabled, clock driven by external oscillator
1 PLL disabled, clock driven by on-chip oscillator
N/A PLL disabled, clock driven by crystal
0 PLL in normal mode, clock driven by external oscillator
1 PLL in normal mode, clock driven by on-chip oscillator
N/A PLL in normal mode, clock driven by crystal
Table 2-6. External Interrupt Signals
Abbreviation
IRQ[7:1] External interrupt sources.
Table 2-7. Queued Serial Peripheral Interface (QSPI) Signals
Abbreviation
QSPI_DOUT Provides the serial data from the QSPI and can be programmed to be
driven on the rising or falling edge of QSPI_CLK.
QSPI_DIN Provides the serial data to the QSPI and can be programmed to be
sampled on the rising or falling edge of QSPI_CLK.
QSPI_CLK Provides the serial clock from the QSPI. The polarity and phase of
QSPI_CLK are programmable.
QSPI_CS[3:0] QSPI peripheral chip selects that can be programmed to be active
high or low.
Configure the Clock Mode
Function
Function
Signal Descriptions
I/O
I
I/O
O
I
O
O
2-9