Connecting Cables; Installing The Ethernet Cables - Patton SmartNode 1000 Series Getting Started Manual

SmartNode 1000 and 2000 Series Getting Started Guide

Connecting cables

Installing SmartNode 1400 cables takes place in the following order:
1. Installing the 10Base-T Ethernet cable into ports ETH 0 and ETH 1 (see
Ethernet cables" on page 85).
2. Installing the BRI 0 and BRI 1 cables (see
3. Installing the power cord (see

Installing the Ethernet cables

Ethernet devices (10Base-T) are connected to the SmartNode's Ethernet ports (see
listing) via a cable terminated with RJ-45 plugs. Use a cross-over cable to connect to a host (see
page 86), or a straight-through cable to connect to a hub (see
Note

Connecting cables

Figure 48. SmartNode 1400 connectors
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
The Interconnecting cables shall be acceptable for external use and shall be
rated for the proper application with respect to voltage, current, anticipated
temperature, flammability, and mechanical serviceability
"Installing the BRI cables"
"Installing the power cord"
Table 27. Ethernet 10Base-T (RJ-45) port pin-outs
Pin
1
2
3
6
Pins not listed are not used.
5 • SmartNode 1400 installation
figure
on page 86).
on page 90).
table 27
figure 50 on page 86).
Signal
TX+
TX-
RX+
RX-
48) (see "Installing the
for port pin-out
figure 49 on
85