Installing Cables; Connecting Isdn Terminals And Nt To The Smartnode's Isdn Bri Ports; Connecting The 10/100/1000Base-T Ethernet Wan Cable - Patton SmartNode 4131 User Manual

SmartNode 4131 User Manual

Installing cables

WARNING
WARNING
Connect the cables in the following order:
1. Connect the ISDN terminals and NT to the BRI ports (see section
to the SmartNode's ISDN BRI
2. Connect the 10/100/1000Base-T Ethernet WAN (see section
net WAN cable")
3. Connect the power mains cable (see section ,

Connecting ISDN terminals and NT to the SmartNode's ISDN BRI ports

The SmartNode comes with two or four ISDN BRI ports located on the rear panel (see
port can be connected to the PSTN (ISDN NT) or terminals.
CAUTION
On Lifeline Relay models (/R option) the PSTN line should be connected to
Note
BRI 0/0 and a terminal to BRI 0/1 to benefit from the lifeline function
(requires /R option, see the full list of models on www.patton.com).
For details on the BRI port pinout and ISDN cables, refer to
D, "Port pin-outs" on page

Connecting the 10/100/1000Base-T Ethernet WAN cable

The SmartNode 4131 has automatic MDX (auto-cross-over) detection and configuration on the Ethernet port.
The port can be connected to a host or hub/switch with a straight-through wired cable.
• Connect to the subscriber port of the broadband access modem (DSL, cable, WLL) to ETH 0/0.
For details on the Ethernet port pinout and cables, refer to
D, "Port pin-outs" on page 49.
Installing the Patton SmartNode Gateway
Do not work on the system or connect or disconnect
cables during periods of lightning activity.
The Interconnecting cables shall be acceptable for external
use and shall be rated for the proper application with
respect to voltage, current, anticipated temperature, flam-
mability, and mechanical serviceability.
ports")
"Connecting the Power Supply"
For the ISDN connection to a carrier Network, it shall be con-
nected to a Network Termination Device and not connected
directly to an outside POTS line.
49.
"Connecting ISDN terminals and NT
"Connecting the 10/100/1000Base-T Ether-
on page 27)
Appendix C, "Cabling"
Appendix C, "Cabling"
3 • SmartNode Installation
figure 2 on page 16). All
on page 45 and Appendix
on page 45 and Appendix
26