Rear Panel - Patton SmartNode 1000 Series Getting Started Manual

1 • General Information
See chapter 11, "Monitoring Status"

Rear panel

The SmartNode 1400 rear panel includes the following LEDs for at-a-glance status display (see
• LINK LEDs that indicate the status of the Ethernet connections
• L2 LEDs that show the status of the BRI interfaces
The ports are described in
C, "Port pin-outs" on page 177 for pin-out data).
Port Description
10Base-T Ethernet RJ-45 socket that connects the SmartNode with an Ethernet device
ETH 0
(usually a transmission modem, i.e. cable or DSL modem). ETH 0 is a host port; depend-
10Base-T (Modem)
ing on the pin out of the modem, it can be connected with a straight-through wired
cable or a cross-over cable. The LINK LED to the left of the connector is lit when the port
is connected correctly to an active Ethernet device.
26
Figure 6. SmartNode 1400 front panel
on page 151 for more information on LED indications.
table 6 (see appendix B,
Figure 7. SmartNode 1400 rear panel
Table 6. SmartNode 1400 port description
SmartNode 1000 and 2000 Series Getting Started Guide
"Cabling" on page 165 for connection cable and appendix
figure 4):
SmartNode 1400 description