Table of Contents
Advertisement
SmartNode 1000 and 2000 Series Getting Started Guide
Rear panel
The SmartNode 2400 rear panel is depicted in
cards, and four board-mounted sockets. There are four expansion slots for optional interface cards, and four
board-mounted sockets. The Link, and 100Mb/s LEDs indicate the status of the Ethernet ports. See appendix
B,
"Cabling"
on page 165 for connection cable and appendix C,
Expansion slots
The slots labeled SLOT 1, SLOT 2, SLOT 3 and SLOT 4 (see
integrate voice and data over IP networks (see "Interface cards descriptions" on page 35 for more information).
On-board ports
Three motherboard-mounted network interfaces are available for use, independent of those that may be
included with interface cards mounted in SLOT 1, SLOT 2, SLOT 3, or SLOT 4. The motherboard-mounted
ports are described in
table 11
"Port pin-outs"
on page 177 for pin-out data).
Port
Ethernet RJ-45 socket that connects the SmartNode with an Ethernet device, such as a
ETH 0/1
(10/100BaseT)
wide area transmission modem, Ethernet hub, or switch. ETH 0/1 is a host port; it can
be connected with a straight-through wired cable to a hub, or a cross-over cable to a
host port. The Link LED is lit when the port is connected correctly to an active Ethernet
device. The 100Mb/s LED is lit when the port is connected correctly to an active
100Base-T Ethernet device.
Ethernet RJ-45 socket that connects the SmartNode with an Ethernet device, such as a
ETH 0/0
(10/100BaseT)
wide area transmission modem, Ethernet hub, or switch. ETH 0/0 is a host port; it can
be connected with a straight-through wired cable to a hub, or a cross-over cable to a
host port. The Link LED is lit when the port is connected correctly to an active Ethernet
device. The 100Mb/s LED is lit when the port is connected correctly to an active
100Base-T Ethernet device.
SmartNode 2400 description
figure
13. There are four expansion slots for optional interface
Figure 13. SmartNode 2400 rear panel
(see appendix B,
"Cabling"
Table 11. SmartNode 2400 port description
"Port pin-outs"
on page 177 for pin-out data.
figure
13) accept different PMC interface cards to
on page 165 for connection cable and appendix C,
Description
1 • General Information
33
Advertisement
Table of Contents
