Table of Contents
Advertisement
SmartNode 1000 and 2000 Series Getting Started Guide
Hardware installation
SmartNode 2300 installation consists of the following:
Note
•
Installing an interface card (if the card was not installed at the factory). Refer to chapter 9,
installation"
on page 133 to install the card, then return to this chapter.
•
Placing the device at the desired installation location (see section
page 93)
•
Installing the interface and power cables (see section
When you finish installing the SmartNode 2300, go to chapter 10,
Device"
on page 139.
Mounting the SmartNode 2300
The SmartNode 2300 should be placed in a dry environment with sufficient space to allow air circulation
for cooling.
Note
The SmartNode 2300 can be installed as follows:
•
Placed on a desktop or similar sturdy, flat surface that offers easy access to the cables
•
Mounted inside a 19-inch equipment rack
Note
Hardware installation
If you will be installing the 48V line power module prior to installing
an interface card or ISDN S-Bus, refer to chapter 8,
module installation"
on page 125.
For proper ventilation, leave at least 2 inches (5 cm) to the left, right,
front, and rear of the SmartNode 2300.
To prevent overheating we recommend that the SmartNode 2300 not
be installed in a closed rack or in a room that is not properly venti-
lated or air-conditioned.
6 • SmartNode 2300 installation
"Line power
"Mounting the SmartNode 2300"
"Connecting cables"
on page 96)
"Getting Started with the SmartNode
"Interface card
on
93
Advertisement
Table of Contents
