Powering Down; Dc Power Connection(S); Dc Power Cables - Patton SmartNode 10100 Series User Manual

SmartNode 10100 Series User Manual

Powering Down

Powering down the SN10100 requires that the Linux embedded host be shut down. In order to do this, you
must connect to the management interface using SSH, and enter:
shutdown -hp now
IMPORTANT
Connecting Power
Figure 8. DC Power Connection(s)
Table 4. DC Power Cables
Cable Type
OV/Ground
Yellow/Black
Red/Black
DO NOT TURN OFF the power to the SN10100 using the
power switch located at the rear, unless the Linux host has been
properly shut down beforehand, using the reset button display, or
manually using the shutdown command.
Allow enough time for the Linux host to shut down before turning
the power to the SN10100 off (e.g. 1 min). Be aware that the
shutdown procedure of the unit is logged and traceable for sup-
port and warranty purposes.
Voltage
-48V
Black Yellow
Red Black
2 • Hardware Installation
25