Hardware Installation; Mounting The Smartnode 1200; Desktop Installation - Patton SmartNode 1000 Series Getting Started Manual

SmartNode 1000 and 2000 Series Getting Started Guide

Hardware installation

SmartNode 1200 installation consists of the following:
• Placing the device at the desired installation location (see section
page 71)
• Installing the interface and power cables (see section
When you finish installing the SmartNode 1200, go to chapter 10,
Device" on page 139.

Mounting the SmartNode 1200

The SmartNode 1200 should be placed in a dry environment with sufficient space to allow air circulation for
cooling.
Note
The SmartNode 1200 can be installed as follows:
• Placed on a desktop or similar sturdy, flat surface that offers easy access to the cables
• Mounted on a wall

Desktop installation

Do the following to install the SmartNode 1200:
1. Remove one of the rubber pads from the adhesive strip (included in the SmartNode installation kit pack)
and place it on a corner on the bottom of the SmartNode 1200 (see

Hardware installation

For proper ventilation, leave at least 2 inches (5 cm) to the left, right,
front, and rear of the SmartNode 1200.
Figure 36. Pads and wall-mounting keyholes locations
4 • SmartNode 1200 installation

"Mounting the SmartNode 1200"

"Connecting cables" on page 73)
"Getting Started with the SmartNode
figure 36).
on
71