SmartNode 1000 and 2000 Series Getting Started Guide
S LO
T
3
S LO
T
2
RJ-48C, male
TX Ring
TX Tip
TX Shield
RX Ring
RX Tip
RX Shield
Installing the IC-T1V interface card cables
The PRI is usually connected to a PBX or telco switch—local exchange (LE). The type and pin outs of these
devices vary depending on the manufacturer. In most cases, a straight-through RJ-45 to RJ-45 can be used to
connect the PRI (see
table 40
cross-over cable is required to connect to an LE, as illustrated in
Connecting cables
S LO
T
1
Figure 77. Connecting an E1 PRI port to an NT
1
2
3
4
5
6
Figure 78. E1 crossover cable
The Interconnecting cables shall be acceptable for external use and shall be
rated for the proper application with respect to voltage, current, anticipated
temperature, flammability, and mechanical serviceability
for IC-T1V card port pin-out listing) with a PBX (an NT) (see
7 • SmartNode 2400 installation
NT
RJ-48C, male
1
2
3
4
5
6
figure
80.
figure
79). A
121