Rear Panel - Patton SmartNode 1000 Series Getting Started Manual

SmartNode 1000 and 2000 Series Getting Started Guide

Rear panel

The SmartNode 1200 rear panel includes the following LEDs for at-a-glance status display (see
• LINK LEDs that indicate the status of the Ethernet connections
• L2 LEDs that show the status of the BRI interfaces
The ports are described in
C, "Port pin-outs" on page 177 for pin-out data).
Port Description
10Base-T Ethernet RJ-45 socket that connects the SmartNode with an Ethernet device
ETH 0
10Base-T (Modem) (usually a transmission modem, i.e. cable or DSL modem). ETH 0 is a host port; depend-
ing on the pin out of the modem, it can be connected with a straight-through wired
cable or a cross-over cable. The LINK LED to the left of the connector is lit when the port
is connected correctly to an active Ethernet device.
10Base-T Ethernet RJ-45 socket that connects the SmartNode with an Ethernet device,
ETH 1
10Base-T (LAN) usually a LAN hub or switch. ETH 1 is a host port; it can be connected with a straight-
through wired cable to a hub or a cross-over cable to a host (PC) port. The LINK LED to
the left of the connector is lit when the port is connected correctly to an active Ethernet
device.
ISDN BRI RJ-45 socket that connects the SmartNode with an ISDN network termination
BRI 0
ISDN T (Line) (NT). The interface may be used as a fallback port. The L2 LED to the left of the connector
is lit when the port is connected correctly to an active ISDN device (Layer 1 is up). The
interface is internally terminated at 100 ohm. It may be powered by an external power
supply to feed TEs connected to BRI 1. Refer to appendix B,
connection details.
Note
Note
SmartNode 1200 description
table 3 (see appendix B,
Figure 4. SmartNode 1200 rear panel
Table 3. SmartNode 1200 port description
External S-Bus power supplies must comply with the voltage and cur-
rent limits set by ISDN standards, i.e. max. 40 VDC and 200 mA.
The L2 LED indication depends on the connected device.
"Cabling" on page 165 for connection cable and appendix
1 • General Information
figure 4):
on page 165 for
"Cabling"
23