Clock Mode Configuration (Model Sn1200); Smartnode 1400 Description; Front Panel - Patton SmartNode 1000 Series Getting Started Manual

SmartNode 1000 and 2000 Series Getting Started Guide
Clock mode configuration (Model SN1200)
The following table shows which clock mode configurations are allowed for the SmartNode 1200 and which
port is used as the clock source.
Table 5. Clock-modes and clock-sources for the SmartNode 1200
Port 0 Port 1
Clock Mode Clock Mode
Slave (User) Master (Net)
Master (Net) Slave (User)

SmartNode 1400 description

The SmartNode Model 1400 (see
The interfaces consist of two ISDN BRI ports and two Ethernet 10Base-T ports. It is suitable for enterprise net-
working and small office environments. The ventilated metal case can be wall-mounted or placed on a desktop.

Front panel

The Model 1400 front panel (see
• POWER and RUN LEDs that indicate the device status
• BRI0, BRI1, ETH0, and ETH1 LEDs that indicate the status of the interfaces

SmartNode 1400 description

Port 0. This is the only configuration that is supported on the SmartNode
1200.
Clock is taken from port 0 if available. Otherwise it is generated internally.
Not supported
figure 5) is a compact voice/data access device that supports four voice channels.
Figure 5. Model 1400 (front and rear views shown)
figure 7) includes the following LEDs for at-a-glance status display:
1 • General Information
Clock Source
25