Login; Changing The Ip Address - Patton SmartNode 1000 Series Getting Started Manual

SmartNode 1000 and 2000 Series Getting Started Guide
Terminal emulation program settings:
• 9600 bps
• no parity
• 8 bit
• 1 stop bit
• 1 start bit
• No flow control

Login

Accessing your SmartNode via the local console port (or via a Telnet session) causes the login screen to display.
Type the factory default login: administrator and leave the password empty. Press the Enter key after the pass-
word prompt.
login:administrator
password: <Enter>
172.16.40.1>
After you have successfully logged in you are in the operator execution mode, indicated by > as command line
prompt. With the commands enable and configure you enter the configuration mode.
172.16.40.1>enable
172.16.40.1#configure
172.16.40.1(cfg)#

Changing the IP address

Select the context IP mode to configure an IP interface.
1. Configure IP address
10 • Getting Started with the SmartNode Device
Figure 88. Connecting to the terminal
143