Patton SmartNode 1000 Series Getting Started Manual page 24

1 • General Information
Port Description
ISDN BRI RJ-45 socket that connects the SmartNode with an ISDN S-Bus, e.g. a PBX.
BRI 1
The L2 LED to the left of the connector is lit when the port is connected correctly to an
ISDN S (Phone)
active ISDN device (Layer 1 is up). The interface is internally terminated at 100 ohm.
Note
RS-232 RJ-45 connector that connects the SmartNode with a serial terminal such as a
Console
PC or workstation with an RS-232 interface, with the following settings:
(RS-232)
•
•
In addition, two other elements—the Reset button and power input socket—are available on the rear panel of a
SmartNode 1200 as described in
Table 4. SmartNode 1200 Reset button and power line socket on rear panel
Element
Reset button The button has three different functions:
Manual Restart—During normal operation, pressing and releasing the reset button
•
will cause a system reboot. The application will be restarted without any change to the
existing SmartWare configuration.
Restoration—Pressing and holding the reset button for 5 seconds will restore the fac-
•
tory configuration and automatically reboot the system.
Note
Boot loader—Powering the SmartNode while pressing the reset button for 5 seconds
•
will cause the factory-fitted boot loader to start in place of the application. The boot
loader uses a minimal set of parameters. In case the application does not start correctly,
the boot loader can be used as a fallback to download a new software version.
100–240 VAC Electricity supply socket for mains power cable.
50/60 Hz
24
Table 3. SmartNode 1200 port description (Continued)
The L2 LED indication depends on the connected device.
9600 bps, no parity, 8 bit, 1 stop bit, 1 start bit
The console port is only used for service and maintenance
Do not plug in an ISDN connection. The voltage on the S-Bus
may permanently damage the console interface.
table 4.
In this case the existing IP SmartWare configuration is lost.
SmartNode 1000 and 2000 Series Getting Started Guide
Description
SmartNode 1200 description