Installing The Power Cord - Patton SmartNode 1000 Series Getting Started Manual

SmartNode 1000 and 2000 Series Getting Started Guide

Installing the power cord

Do the following:
1. Insert the barrel type connector end of the AC power cord into the 100–240 VAC power connector (see
figure 71).
Note
2. Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to chapter 12,
compatible power cord.
3. Connect the male end of the power cord to an appropriate power outlet.
4. Verify that the green PWR LED is lit (see
5. Unplug the power cord from the router to power down the unit.
Congratulations, you have finished installing the SmartNode 2400! Now go to chapter 10,
with the SmartNode Device"
Connecting cables
The SmartNode 2400 power supply automatically adjusts to
accept an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
Do not connect the other end of the power cord to the power outlet at
this time.
"Contacting Patton for assistance"
figure
Figure 81. SmartNode 2400 front panel LEDs
on page 139.
7 • SmartNode 2400 installation
on page 155 to find out how to replace it with a
81).
"Getting Started
123