Table of Contents
Advertisement
1 • General Information
Jumper settings for IC-4BRV and PM-48V-INT (or PM-40V-INT). The following are possible jumper set-
tings for IC-4BRV and PM-48V-INT (or PM-40V-INT) fitted in SmartNode SmartNode 2000 Series:
•
No jumpers are set: this setting is used with ports 2 and 3 configured in USR mode and connected to NTs
as shown in
figure
21.
•
Upper four jumper pins bridged: this setting is used with port 2 configured as fallback and connected to a
NT as shown in
figure 22
•
All eight jumper pins bridged: this setting is used with all four ports configured in NET mode and con-
nected to line powered terminals as shown in
42
on page 43.
figure 23
Figure 21. No jumpers set
SmartNode 1000 and 2000 Series Getting Started Guide
on page 43.
Interface cards descriptions
Advertisement
Table of Contents
