Connecting Power; Connecting To Ac Power; Port Interface To The Pstn - Patton SmartNode 10100 Series User Manual

SmartNode 10100 Series User Manual

Connecting Power

The SN10100 is furnished with two AC or DC power connections. Only once all other equipment installation
work has been completed should the SN10100 be powered up.
To power the SN10100, you will need:
A power source
•
Two power cables for the SN10100
•
Refer to the following sections for information about power:
•

"Connecting to AC Power"

"Connecting to DC Power"
•
"Powering Down" on page 25
•

Connecting to AC Power

The SN10100 AC model is furnished with two AC power connectors.
To connect the SN10100 to AC Power perform the following:
1. Connect an AC power cable between the AC connector of the SN10100 and an AC supply
If the SN10100 features a second power supply and it is not connected to an
Note
AC power source, press the green button located at the rear of the unit to dis-
able the audible alarm.
2. Power up the SN10100 by turning on its power switch(es).

Connecting Power

Figure 6. Port Interface to the PSTN
on page 23
on page 24
2 • Hardware Installation
(Figure 7).
23