Table of Contents
Advertisement
1.
Connect AC power cables between the AC connectors of the SN10100A and the
two independent power sources (see
2.
Verify that the Power LED on the front panel (see
0
1
2
3
8
4
5
6
7
12
1.
Connect to the Control host through the console serial port (see
the console serial port"
7.2 "Connecting the Ethernet management interface"
The IP address of the management port is 192.168.200.10/24. If it is not possible
to connect to the management port via IP, use the serial cable to connect to the
SmartNode Control host for the first time.
2.
Default HOSTNAME is the Control host serial number, which can be found in the
"Important Notice" sheet included with your shipment.
3.
Refer to the "Important Notice" sheet for the username and password to log onto
the SmartMedia WebPortal. Navigate to: HTTP://HOSTNAME:12358, to configure
the SmartNode unit. (username/password: root/root)
SmartNode 10100A Series Quick Start Guide
6.0 Connecting to the power source
9
10 11
MGMT0
ETH0
13
14
15
MGMT1
ETH1
Figure 5.
Figure 6.
7.0 Connecting to the Control host
on page 8) OR the Ethernet management interface (see
figure
5).
VOIP0
VOIP1
Connecting the power source
Power LED
Power LED location
figure
6) is a solid green.
AC
Power
Source 2
7.1 "Connecting
on page 8).
7
Advertisement
Table of Contents
