Power On - NEC Express5800/340Hb-R N8800-047F User Manual

2-30 General Description

Power ON

To power on NEC Express5800/ft series, press the POWER switch located on the front panel.
Follow the steps below to turn on the power.
1.
Power on the display unit and other peripheral devices connected to the server.
CHECK:
sure that it is powered on.
NOTE:
PCI modules are synchronized. (The BMC status LED on the secondary module
blinks.) See Chapter 2 "LEDs" for details of the BMC status LED.
2.
Remove the front bezel.
3.
Confirm that the BMC status LED on both PCI modules are off and press the POWER
switch which illuminates green and located on the front panel.
After a while, the "NEC" logo will appear on the screen.
IMPORTANT:
Do not turn off the power before the "NEC" logo appears.
Before powering on, make sure that the BMC status LED on the both PCI
modules are off and then press the power switch.
While the "NEC" logo is displayed on the screen, NEC Express5800/ft series is
performing a power-on self test (POST) to check itself. For details, see "Power-On Self
Test (POST)" described later in this manual. Upon the completion of POST, Windows
Server 2003 will start.
If the power cord is connected to a power controller like a UPS, make
When NEC Express5800/ft series is powered on, BMCs between the two
POWER switches* (LEDs)
* You can only use a power
switch whose LED is on.