NEC Express5800/340Hb-R N8800-047F User Manual page 118

3-42 Windows Setup and Operation
IMPORTANT:
will not be recognized due to the failover of the PCI module. Thus be sure to stop the
services before starting the PCI module.
1. Start [Services] from [Administrative Tools] of [Control Panel].
2. Select a service of backup software.
3. Choose "Stop" from the "Action" menu.
4. Repeat 2 and 3 for all services of the backup software.
The PCI modules' status LEDs changes as shown below:
[Indications of the status LEDs]
Immediately after the PCI module startup until the completion of diagnosis
BMC status LED
1
PCI module status LED1
2
PCI module status LED2
3
DISK ACCESS LED
4
DISK LED
When duplication of disks is started after the completion of PCI module diagnosis
* The status of LEDs differ depending on the method of disk duplication.
1 BMC status LED
2 PCI module status LED1
3 PCI module status LED2
4 DISK ACCESS LED
DISK LED
After the completion of disk duplication and when the PCI modules are duplicated
1 BMC status LED
2 PCI module status LED1
3 PCI module status LED2
4 DISK ACCESS LED
DISK LED
If BrightStor ARCserve 2000 or Backup Exec is installed, the tape
LED
LED
LED
Secondary
Green
Red
Green
-
Green
Secondary
Non-RDR RDR
model model
Green Green
-
Amber Green
Amber Green
Amber Green
Secondary
Green
-
Green
Green or off
Green
Primary
Green
-
Amber
Amber
Amber
Primary
Green
- -
Amber
Amber
Amber
Primary
Green
-
Green
Green or off
Green