NEC Express5800/340Hb-R N8800-047F User Manual page 150

4-26 System Configuration
SCSI Device Settings
If you put the cursor on "SCSI Device Settings" with keyboard cursors (↓ and ↑) in the
"Configuration Settings" menu and press Enter, the screen for setting the information on the device
connected to the host adapter appears.
The table below shows the parameters of the setting items and their settings at shipment.
IMPORTANT: The settings can be done in SCSI buses. The settings at shipment are the same
for both SCSI bus 0 and SCSI bus 1.
Submenu item Parameter
Disconnects OK [Yes]
No*
Check Parity [Yes]
No
Enable LUNs [Yes]
No
Enable PPR Yes
[No]
Enable Device [Yes]
No
Negotiate Wide [Yes]
No*
Negotiate Sync [Yes]
No*
Tagged Queuing [Yes]
No*
Sync Offset 00, 02, 04, 06, 08, 10, 12, 14,
16, 18, 20, 22, [24]
Sync Period [Ultra3 9
Ultra2 10
Ultra
Fast
Exec Throttle 1, 4, 8, [16], 32, 64, 128, 255 Leave this item as factory-set.
= 160MB/s]
= 80MB/s
12 = 40MB/s
25 = 20MB/s
40 = 12.5MB/s
Description
Specify whether the disconnection of SCSI
devices from the SCSI bus is enabled or
disabled.
* "No" must be selected for ID8.
Specify whether the parity check is provided or
not.
Specify whether more than one LUN numbers
are given to SCSI ID.
Leave this item as factory-set.
Leave this item as factory-set.
Specify whether the wide (32 bits) transfer is
enabled or disabled.
* "No" must be selected for ID8.
Specify whether the synchronous transfer is
enabled or disabled.
* "No" must be selected for ID8.
Leave this item as factory-set.
* "No" must be selected for ID8.
Select the proper offset value in synchronous
transfer.
Select the proper speed in synchronous transfer.
[ ]: Factory-set