Relocating/Storing The Nec Express5800/Ft Series - NEC Express5800/340Hb-R N8800-047F User Manual

6-10 Maintenance

RELOCATING/STORING THE NEC Express5800/ft series

Follow the procedure below to relocate or store the server. (Users should not attempt to remove the
rack-mountable server from the rack assembly.)
Do not attempt to remove the server.
To avoid the risk of personal injury, users should not attempt to remove the
server from the rack assembly. Removal of the server from the rack assembly
should be performed by suitably trained maintenance personnel.
Observe the following instructions to use the server safely. There are risks of a
fire, personal injury, or property damage. See "PRECAUTIONS FOR SAFETY"
in Chapter 1 for details.
IMPORTANT:
If the server needs to be relocated/stored due to a change in the floor layout to a great
extent, contact the sales agent.
Make sure to make a backup copy of your valuable data in the hard disk, if any.
When moving the server with hard disks, make sure not to give a shock to the hard disks.
When storing the server, keep it under storing environment conditions (temperature: -10 to
55°C, humidity: 20 to 80%, non-condensing).
1.
Remove the front bezel.
2.
Take a floppy disk and a CD-ROM out of the server, if any.
3.
Power off the server.
4.
Unplug the power cord of the server from a power outlet.
5.
Remove all the cables from the server.
6.
Remove the server modules from the rack cabinet.
7.
Hold the CPU module by its bottom with at least two persons to carry it.
To carry the PCI module or expansion PCI module, hold it by its bottom.
Never attempt to lift the CPU module only by yourself.
Do not install the server in any place other than specified.
Do not connect/disconnect any interface cable with the power cord of the
server plugged to a power source.
WARNING
CAUTION