NEC Express5800/340Hb-R N8800-047F User Manual page 138

4-14 System Configuration
Option Parameter Description
Boot Monitoring 1 - [10] - 20 Specify the boot monitoring time-out period. This
Time-out Period
POST Pause Disabled
Monitoring
[Enabled]
POST Pause 1 - [3] - 20
Monitoring
Time-out
IMPORTANT:
When connecting a Fibre Channel disk array device, change the set value of "Boot
Monitoring Time-out Period" depending on the wait time for the completion of the Fibre
Channel disk array device initialization.
If the wait time for the completion of the Fibre Channel disk array device initialization is 4
minutes, change the value of "Boot Monitoring Time-out Period" from 10 (default) to 14
minutes.
If you set a small value for "Boot Monitoring Time-out Period", you can shorten the
waiting time to the rebooting. It recommended to set a value of more than 3 minutes though
smaller value setting is available when external devices are not used. As it depends on the
user's setting environment, make sure to execute enough evaluation after the configuration
of the environment.
option is displayed only when "Enabled" is selected
for "Boot Monitoring". If you specify a shorter period
of time to "Boot Monitoring Time-out Period", the
time until rebooting can be reduced. When there is
no external device connected, it is possible to set a
shorter period of time, but 3 minutes or longer is
recommended. Appropriate value for the setting
varies depending on your environment. Therefore,
when changing this setting, evaluate it thoroughly
after constructing the environment.
Enable or disable the POST monitoring feature
during boot-up restriction.
Specify the POST monitoring time period during
boot-up restriction.
Your Setting
[ ]: Factory-set