NEC Express5800/340Hb-R N8800-047F User Manual page 182

5-24 Installing and Using Utilities
When [FTServer] Tree Appears on Date Viewer in an Incorrect Manner
If you open a Data Viewer immediately after the system starts up, the tree or the state of a Data
Viewer may not be displayed correctly due to high load of the system. In about 20 minutes after the
system startup, when a pop-up message (below) which prompts you to reconstruct a Data Viewer
appears, click [OK]. The Data Viewer will be reconstructed and the tree and the status will be
displayed correctly.
Data Viewer
The system configuration of the host may have been changed. Do you wish to reconstruct the
tree?
Floppy Disk Drive Name
After unplugging and plugging the PCI module of the primary side, the floppy disk drive name of
[I/O Device] on Data Viewer may be different from the name that is recognized by the OS.
(Example: drive name on Data Viewer: "A"
Check the floppy disk drive name on Explorer.
Floppy Disk Drive Information
If you add or delete floppy disk drive connected with USB while the system is running, the drive
information under the [I/O Device] in the data viewer will be updated at the next system startup.
Displayed BIOS Data Is Incorrect
BIOS additional data may not be displayed properly in [BIOS Information] of a CPU Module of the
ft server utility or in [Ft Server] – [CPU Module] – [Individual CPU Module] – [General] – [BIOS
Information] of Data Viewer.
In this case, see the data in [ESMMIB] – [BIOS] of Data Viewer.
Ethernet Adapters You Do Not Use
If an Ethernet adapter is not used (not connected to cable), set it to "Disable" in [Network
Connections] from Control Panel. If an Ethernet adapter you are about to disable has dual LAN
settings (AFT function), remove the dual LAN settings before disable it.
drive name recognized by the OS: "B")