N8804-001P1 100Base-Tx Adapter Set - NEC Express5800/340Hb-R N8800-047F User Manual

N8804-001P1 100BASE-TX Adapter Set

Slots to install the board
IMPORTANT:
Note the following about this product:
For LAN cable's connector, use the RJ-45 connector which is compliant with IEC8877 standard.
Using a different connector may make it difficult to remove the connector.
N code
N8804-001P1 100BASE-TX adapter
√: Can be installed. –: Cannot be installed.
IMPORTANT:
The server can contain up to six sets of PCI boards: optional PCI board
(N8804-001P1, N8104-84, or N8104-103) and internal LAN controller (100BASE-TX or
1000BASE-SX).
Installation of driver
The NEC Express5800/ft series duplicates one or two pairs of 100BASE-TX adapter sets
(N8804-001P1) before using.
After installing Operating System, install the drivers in the following procedure and make dual
settings of the PCI board.
NOTE:
To perform this procedure, you have to log on the system as an Administrator or a
member of the Administrators group.
1.
Mount the N8804-001P1 100BASE-TX adapter to the slot with the same number in PCI
module or expansion PCI module, and then start Windows Server 2003, Enterprise
Edition.
After starting Windows Server 2003, Enterprise Edition, the drivers are installed
automatically.
IMPORTANT:
[Yes] button.
PCI slot for
PCI module
Name
Group 1
#1 #2 #3 #1 #2 #3 #1 #2 #3 #1 #2 #3
– √ √ – √ √ √ √
If the [Digital Signature Not Found] dialog box appears, click the
PCI slot for
expansion PCI module
Group 2 Group 1
√
Option 8-17
Remarks
Group 2
√ √ √