Cleaning - NEC Express5800/340Hb-R N8800-047F User Manual

6-4 Maintenance

Cleaning

Clean the server on a regular basis to keep the server in a good shape.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See
"PRECAUTIONS FOR SAFETY" in Chapter 1.
Cleaning the NEC Express5800/ft series
For daily cleaning, wipe the external surfaces of the server with a dry soft cloth. Follow the
procedure below if stains remain on the surfaces:
IMPORTANT:
To avoid altering the material and color of the server, do not use volatile solvents such
as thinner or benzene to clean the server.
The power receptacle, the cables, the connectors on the rear panel of server, and the
inside of the server must be kept dry. Do not moisten them with water.
1.
Make sure that the server is powered off.
2.
Unplug the power cord of the server from a power outlet.
3.
Wipe off dust from the power cord plug with a dry cloth.
4.
Soak a soft cloth in neutral detergent that is diluted with cold or warm water, and squeeze
it firmly.
5.
Rub off stains on the server with the cloth prepared in Step 4.
6.
Soak a soft cloth in water, squeeze it firmly and wipe the server with it once again.
7.
Wipe the server with a dry cloth.
8.
Wipe off dust from the fan exhaust opening on the rear of the server with a dry cloth.
Do not disassemble, repair, or alter the server.
Do not look into the CD-ROM drive.
Disconnect the power plug before cleaning the server.
WARNING