5-2 Installing and Using Utilities
NEC EXPRESSBUILDER
The NEC EXPRESSBUILDER, integrated setup software, can automatically detect the hardware
connected to an NEC Express5800/ft series machine to advance the processing. The hardware
subject to setup with the NEC EXPRESSBUILDER should have the same configuration as that for
operation.
Start Menu
The NEC EXPRESSBUILDER provides two procedures to start the server as described below. The
menus and items appearing on the screen vary depending on the procedures.
Booting (starting) the server from NEC EXPRESSBUILDER CD-ROM
For the procedure, insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM
drive of the NEC Express5800/ft series and start the NEC Express5800/ft series from the
system in the NEC EXPRESSBUILDER. When the NEC Express5800/ft series is started
by using this procedure, the NEC EXPRESSBUILDER top menu shown above appears.
Perform the NEC Express5800/ft series setup from this menu.
IMPORTANT:
Don't use this CD-ROM on computers other than NEC Express5800/ft series
with which it is packaged (including other NEC Express5800 models).
Otherwise, a breakdown may result.
The execution of "Setup" of the menu causes the OS installed previously to be
erased. OS must also be reinstalled.
See "NEC EXPRESSBUILDER Top Menu" for details.