Configuring The Virtual Mobileextsp Board; Virtual Mobileextsp Board - Altigen MAXCS ACC 6.5 Administration Manual

For information on configuring the T1/E1 trunk, see "Triton T1/E1 Trunk Properties"
•
on page 163.
For information on configuring the Triton Analog Trunk, see "Triton Analog Trunk GS/
•
LS Properties" on page 166.
For information on configuring a Triton Analog Line, see "Triton Analog Station Line
•
Properties" on page 202.
In the main Board Configuration dialog box for the MAX 1000/2000 board (see Figure 20
on page 148) clicking the Board Configuration button opens the following dialog box.
Figure 21. MAX 1000/2000 Board Configuration window
This dialog box displays the board serial number, top access card serial number, bottom
access card serial number, DSP clock, board ID, physical ID, and logical ID. You can
choose to configure the board as either T1 or E1, then click OK. Additional steps are
needed to further configure the CAS or PRI protocol in the Protocol Configuration
window, shown in Figure 9 and Figure 10.
(For information on adding and removing mobile trunks, see "Mobile Extension
Configuration" on page 249.)

Configuring the Virtual MobileExtSP Board

A simulated physical board—MobileExtSP board—is created in the Softswitch server
when you install the MAXCS system. This single MobileExtSP board handles all mobile
extensions, including those located in other gateways in a multi-gateway system.
Configuring the virtual MobileExtSP board is discussed on page 248 in the chapter
"Mobile Extension Configuration."
Chapter 11: Board Configuration
MAXCS ACC 6.5 Administration Manual 149