Altigen MAXCS ACC 6.5 Administration Manual page 175

Enable Channel—After all above parameters are entered correctly, check this box
•
to activate the channel. The AltiGen system will send authentication to the service
provider to verify the setting.
To copy the information in one row to other rows, select the row and click Copy To. Then
select the rows you want to copy the information to, using CTRL+click and Shift+click
to select several rows. Click OK.
To delete a row, select it and click Delete.
Creating a SIP Trunk Profile
Different SIP service providers may support different ways of sending a caller ID. To
provide callees with a more accurate caller ID, you can create a SIP Trunk Profile for a
particular service provider, when necessary. Otherwise, a default profile is used. Once
you have created a profile, you can select it in the SIP Trunk Configuration Edit box (see
Figure 5).
To create a SIP Trunk Profile, in the SIP Trunk Configuration dialog box shown in
Figure 5, click the SIP Trunk Profile button on the right. The SIP Trunk Profile dialog
box opens:
The fields in this dialog box are described in the following table.
Field
SIP Protocol Field
Description
Not Sent (default)—Do not send transmitted caller ID
FROM Header—Send the caller ID using the SIP FROM
header
P-Preferred Identity—Send the caller ID using the SIP
P-Preferred Identity header
P-Asserted Identity—Send the caller ID using the SIP
P-Asserted Identity header
MAXCS ACC 6.5 Administration Manual 161
Chapter 12: Trunk Configuration