Configuring The Triton Voip Board; Voice Over Ip; Triton Voip Board - Altigen AltiWare OE/ACC Version 5.0 Administration Manual

Parameter
Board Configuration
Reset Board

Configuring the Triton VoIP Board

Voice over IP

VoIP for AltiWare OE runs on an H.323 protocol that allows voice calls to
be made through an IP network. It includes an integrated VoIP gateway to
convert voice calls into IP packets and transmit them through the IP
network. It also has the capability of networking multiple AltiServs into a
virtual PBX network. This enables calls to be made through the IP network,
which allows for significant savings in toll charges.

Triton VoIP Board

AltiWare VoIP uses DSP engines residing on the Triton VoIP board to
perform the voice processing functions needed for H.323 devices.
Quantum and Triton boards are connected via MVIP connectors.
The Triton VoIP board can be configured as a 12-port G.711/G.723.1/
G.729AB or 30-port G.711 board.
Important: Triton 30-port VoIP boards are recommended for use with
local IP extensions only or for tie-trunk configurations to other
30-port VoIP boards. Additionally, to prevent users from
directly accessing the 30-port boards—which use the G.711
codec only—for calls to AltiWare servers or other IP gateways
that may require the G.723 codec, it is recommended that the
trunk access code is set to "None" for trunks on 30-port IP
boards. (See "Setting General Trunk Attributes" on page 7-3
AltiWare OE System Installation & Administration Manual
Description
Displays the board's serial number.
Resets the board, after you confirm resetting by
accepting a warning.
Important:
Resetting a board will disconnect all
calls in progress on that board! Be sure
to inform all users before resetting a
board.
Board Configuration
6-7