Assigning Seat-Based Client Licenses - Altigen MAXCS ACC 6.5 Administration Manual

Chapter 3: Getting Around MaxAdministrator
Total Packet Loss Rate—the ratio of total number of lost packets versus total
•
received packets
Max Packet Loss Rate—the maximum packet loss rate observed over a period of
•
time during a whole session
Jitter —displays the average length of delay per voice packet in milliseconds. This
•
number can be used to measure the quality of service on the network that connects
the source and destination sites. Under 100 milliseconds is good, while a higher
figure indicates a longer than average delay. (See "Setting VoIP Codec Profiles" on
page 330 for more detailed information on jitter.)
Local Ports—displays the local RTP/RTCP port for the voice stream
•
Remote IP Address:Port—displays the remote RTP port for the voice stream
•
Bottom part of the window
Shows information about the MeetMe 30-party conference bridge:
Gateway ID of the 30-party conference board (for example, 00)
•
MeetMe Conference Bridge ID (from 00:00 to 00:09)
•
Number of members currently participating in a conference using each bridge
•
Each system can have only one 30-party MeetMe conference board.
Note:
Setting the Refresh Interval
The Current Resource Statistics window is updated according to the Refresh
Interval configuration. By default, the Refresh Interval is set to refresh the data in
the window every 5 seconds. To change the refresh interval, click the Refresh Interval
button at the top of the window, and set the refresh interval to a number of seconds up
to one minute. To set the time to 0 is to turn off the refresh interval.

Assigning Seat-Based Client Licenses

Most MAXCS client products require either session- or seat-based licenses. You may
have purchased both types. A session license allows a certain number of extensions to
use a client product. If you have purchased seat licenses so that particular extensions
always have access to the client product, those extensions must be assigned to the client
product in MaxAdmin. If an extension is not assigned to a product, that extension may
not be able to use the client product. You may have seat-based licenses for the following
MAXCS client products:
MaxCommunicator
•
MaxOutlook (uses MaxCommunicator license)
•
MaxAgent
•
MaxSupervisor
•
MaxMobile Communicator
•
AltiConsole
•
IP Talk
•
TAPI
•
Integration Connector
•
MaxCall
•
42
MAXCS ACC 6.5 Administration Manual