Triggering Commands; State Storage Commands - Agilent Technologies 33220A User Manual

Triggering Commands

(see page 231 for more information)
These commands are used for Sweep and Burst only.
TRIGger:SOURce {IMMediate|EXTernal|BUS}
TRIGger:SOURce?
TRIGger
*TRG
TRIGger:SLOPe {POSitive|NEGative}
TRIGger:SLOPe?
BURSt:GATE:POLarity {NORMal|INVerted}
BURSt:GATE:POLarity?
OUTPut
:TRIGger:SLOPe {POSitive|NEGative}
:TRIGger:SLOPe?
:TRIGger {OFF|ON}
:TRIGger?

State Storage Commands

(see page 245 for more information)
*SAV {0|1|2|3|4}
*RCL {0|1|2|3|4}
MEMory:STATe
:NAME {0|1|2|3|4} [,<
:NAME? {0|1|2|3|4}
:DELete {0|1|2|3|4}
:RECall:AUTO {OFF|ON}
:RECall:AUTO?
:VALid? {0|1|2|3|4}
:CATalog?
MEMory:NSTates?
Parameters shown in bold are selected following a *RST (reset) command.
Chapter 4 Remote Interface Reference
SCPI Command Summary
State 0 is the instrument state at power down.
States 1 through 4 are user-defined states.
name
>]
"Trig In" Connector
External Gated Burst
"Trig Out" Connector
163
4