Table of Contents
Advertisement
Arbitrary Waveform Errors
The following errors indicate failures that may occur during arbitrary
waveform operation. Refer to "Arbitrary Waveform Commands" on
page 234 for more information.
Nonvolatile arb waveform memory corruption detected
770
The non-volatile memory used to store arbitrary waveforms has detected a
checksum error. The arbitrary waveform cannot be retrieved from memory.
781
Not enough memory to store new arb waveform; use DATA:DELETE
The four non-volatile memory locations already contain arbitrary
waveforms. To store another waveform, you must first delete one of the
stored waveforms using the DATA:DELete command.
Not enough memory to store new arb waveform; bad sectors
781
Due to a hardware error, there are no more memory locations available
to store arbitrary waveforms. This error is likely the result of a failed
Flash memory device.
782
Cannot overwrite a built-in waveform
The following built-in waveform names are reserved and cannot be used
with the DATA:COPY command: "EXP_RISE", "EXP_FALL",
"NEG_RAMP", "SINC", and "CARDIAC".
784
Name of source arb waveform for copy must be VOLATILE
When using the DATA:COPY command, you cannot copy from any source
other than "VOLATILE".
785
Specified arb waveform does not exist
The DATA:COPY command copies the waveform from volatile memory to
the specified name in non-volatile memory. Before executing the
DATA:COPY command, you must download the waveform using the
DATA VOLATILE or DATA:DAC VOLATILE command.
Chapter 5 Error Messages
Arbitrary Waveform Errors
4
5
309
Advertisement
Table of Contents
