Table of Contents
Advertisement
3 Set the "hop" frequency.
Press the Hop Freq softkey and then set the value to 500 Hz using the
numeric keypad or the knob and cursor keys.
4 Set the FSK "shift" rate.
Press the FSK Rate softkey and then set the value to 100 Hz using the
numeric keypad or the knob and cursor keys.
At this point, the function generator outputs an FSK waveform (if the
output is enabled).
5 View the waveform.
Press
to view the waveform parameters.
To turn off the Graph Mode, press
Chapter 2 Front-Panel Menu Operation
To Output an FSK Waveform
again.
2
4
39
Advertisement
Table of Contents
