General - Agilent Technologies 33220A User Manual

General

Power Supply:
Power Consumption:
Operating Environment:
Operating Temperature:
Operating Humidity:
Operating Altitude:
Storage Temperature:
Floating Connector Shields
(Output, Sync, and
Modulation In only):
State Storage Memory:
Interface:
Language:
Dimensions (W x H x D):
Bench Top:
Rack Mount:
Weight:
Safety Designed to:
EMC Tested to:
Vibration and Shock:
Acoustic Noise:
Warm-up Time:
LXI Compliance:
Agilent 33220A Function / Arbitrary Waveform Generator
CAT II
100 to 240 V
@
50/60 Hz (-5%, +10%)
100 to 120 V
@
400 Hz (± 10%)
50 VA maximum
IEC 61010
Pollution Degree 2
Indoor Location
0 °C to 55 °C
5% to 80% RH,
non-condensing
Up to 3000 meters
-30 °C to 70 °C
Shields may float at
± 42 V (peak) relative to
[8]
earth ground.
Power off state
automatically saved.
Four user-configurable
stored states.
GPIB, USB, and LAN
standard
SCPI - 1993,
IEEE-488.2
261.1 mm by 103.8 mm
by 303.2 mm
212.8 mm by 88.3 mm
by 272.3 mm
3.4 kg (7.5 lbs)
UL-1244, CSA 1010,
EN61010
MIL-461C, EN55011,
EN50082-1
MIL-T-28800, Type III,
Class 5
30 dBa
1 hour
LXI Class C,
Version 1.0
Chapter 8 Specifications
Note: Specifications are subject to change
without notice. For the latest specifications,
go to the Agilent 33220A product page and
find the 33220A Datasheet.
www.agilent.com/find/33220A
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à la norme NMB-001
du Canada.
N10149
_________________
Footnotes:
1
Add 1/10th of output amplitude and offset
specification per °C for operation outside
the range of 18
°C to 28 °C
2
Autorange enabled.
3
DC offset set to 0 V.
4
Spurious output at low amplitude is
-75 dBm (typical).
5
Add 1 ppm /
°C (average)
side the range of 18
°C to 28 °C
6
FSK uses trigger input (1 MHz maximum).
7
Sine and square waveforms above 6 MHz
are allowed only with an "infinite" burst
count.
8
These shields must all float at the same
potential to avoid instrument damage.
4
.
for operation out-
.
349
8