Agilent Technologies 33220A User Manual page 294

-221 Settings conflict;
not able to sweep noise, sweep turned off
The function generator cannot generate a sweep using the noise function.
The sweep mode has been turned off.
-221 Settings conflict;
pulse width decreased due to period
For a pulse waveform, the function generator will automatically adjust
the waveform parameters in the following order as needed to generate
a valid pulse: (1) edge time, (2) pulse width or duty cycle, and then (3)
period.
In this case, the function generator has decreased the pulse width to
accommodate the specified period (the edge time is already at its
minimum setting).
Settings conflict;
-221
pulse duty cycle decreased due to period
For a pulse waveform, the function generator will automatically adjust
the waveform parameters in the following order as needed to generate
a valid pulse: (1) edge time, (2) pulse width or duty cycle, and then (3)
period.
In this case, the function generator has decreased the pulse duty cycle to
accommodate the specified period (the edge time is already at its
minimum setting).
-221 Settings conflict;
edge time decreased due to period
For a pulse waveform, the function generator will automatically adjust
the waveform parameters in the following order as needed to generate a
valid pulse: (1) edge time, (2) pulse width or duty cycle, and then (3)
period.
In this case, the function generator has decreased the edge time to
accommodate the specified period and preserve the pulse width setting.
-221 Settings conflict;
pulse width increased due to large period
For a pulse waveform, the minimum pulse width is 20 ns for periods up
to 10 seconds. For periods above 10 seconds, the minimum pulse width is
greater. The function generator has adjusted the pulse width to the new
minimum determined by the current period. See "Pulse Configuration
Commands" in chapter 4 for further information.
Chapter 5 Error Messages
Execution Errors
4
5
293