Table of Contents
Advertisement
-222
Data out of range;
ramp frequency; value clipped to upper limit
This generic message indicates that the waveform frequency has been
limited to an upper boundary due to the selection of the ramp waveform
function (APPL:RAMP or FUNC:RAMP command).
-222
Data out of range;
pulse frequency; value clipped to upper limit
This generic message indicates that the waveform frequency has been
limited to an upper boundary due to the selection of the pulse waveform
function (APPL:PULS or FUNC:PULS command).
-222
Data out of range;
burst period; value clipped to ...
This generic message indicates that the burst period has been limited to
an upper or lower boundary.
-222
Data out of range;
burst count; value clipped to ...
This generic message indicates that the burst count has been limited to
an upper or lower boundary.
-222
Data out of range;
burst period limited by length of burst; value clipped to lower limit
It is not possible to specify a burst period which is too short for the
function generator to output with the specified burst count and
frequency (see below). If the burst period is too short, the function
generator will automatically adjust it as needed to continuously
re-trigger the burst.
Burst Period >
-222
Data out of range;
burst count limited by length of burst; value clipped to upper limit
If the Immediate trigger source is selected (TRIG:SOUR IMM command),
the burst count must be less than the product of the burst period and the
waveform frequency as shown below.
Burst Count
---------------------------------------------------------- -
Waveform Frequency
Burst Count < Burst Period X Waveform Frequency
Chapter 5 Error Messages
Execution Errors
+ 200 ns
4
5
299
Advertisement
Table of Contents
