Table of Contents
Advertisement
To Select the Output Termination
The Agilent 33220A has a fixed series output impedance of 50 ohms to
the front-panel Output connector. If the actual load impedance is
different than the value specified, the displayed amplitude and offset
levels will be incorrect. The load impedance setting is simply provided
as a convenience to ensure that the displayed voltage matches the
expected load.
1 Press
.
2 Navigate the menu to set the output termination.
Press the Output Setup softkey and then select the Load softkey.
3 Select the desired output termination.
Use the knob or numeric keypad to select the desired load impedance or
press the Load softkey again to choose "High Z".
To Reset the Function Generator
To reset the instrument to its factory default state, press
select the Set to Defaults softkey. Press YES to confirm the operation.
For a complete listing of the instrument's power-on and reset conditions,
see "Agilent 33220A Factory Default Settings" on page 151.
Chapter 2 Front-Panel Menu Operation
To Select the Output Termination
2
4
and then
35
Advertisement
Table of Contents
