Table of Contents
Advertisement
-222
Data out of range;
pulse edge time; value clipped to ...
This generic message indicates that the desired edge time is limited to
an upper or lower boundary which is dictated by the instrument
hardware.
-222
Data out of range;
FM deviation; value clipped to ...
This generic message indicates that the desired FM deviation is limited
to a lower or upper boundary as set by the current function's frequency.
Data out of range;
-222
FM deviation limited by minimum frequency
The frequency deviation is limited to the lower limit (1 µHz).
-222
Data out of range;
FM deviation limited by maximum frequency; value clipped to
upper limit
The frequency deviation cannot exceed the carrier frequency, and is
limited as follows: 10.05 MHz for sine or square wave carriers, 150 kHz
for a ramp, or 3.05 MHz for an arbitrary waveform.
-222
Data out of range;
PWM deviation
The PWM deviation is limited. Width deviation can be from 0 to the
width of the underlying pulse waveform. Duty cycle deviation can be
from 0 to the duty cycle of the underlying pulse waveform. Both are
further limited by the minimum pulse width and edge time parameters.
Data out of range;
-222
PWM deviation limited by pulse parameters
The PWM deviation is limited by the current pulse parameters. The
PWM deviation (width or duty cycle) is set to accommodate the current
pulse width or duty cycle, edge time, and period.
Chapter 5 Error Messages
Execution Errors
4
5
301
Advertisement
Table of Contents
