Beeper Control; Display Bulb-Saver - Agilent Technologies 33220A User Manual

20 mhz waveform generator
Table of Contents

Advertisement

3
Chapter 3 Features and Functions
System-Related Operations

Beeper Control

Normally, the function generator will emit a tone when an error is
generated from the front-panel or over the remote interface. You may
want to disable the front-panel beeper for certain applications.
• The beeper state is stored in non-volatile memory and does not
change when power has been off or after a remote interface reset.
When shipped from the factory, the beeper is enabled.
• Turning off the beeper does not disable the key click generated when
you press a front-panel key or turn the knob.
• Front-Panel Operation: Press
from the "System" menu.
• Remote Interface Operation:
SYSTem:BEEPer
SYSTem:BEEPer:STATe {OFF|ON}

Display Bulb-Saver

The front-panel display bulb will normally turn off and the screen will go
blank after 8 hours of inactivity. For certain applications, you may want
to disable the bulb-saver feature. This feature is available from the
front panel only.
• The bulb-saver setting is stored in non-volatile memory and does not
change when power has been off or after a remote interface reset.
When shipped from the factory, the bulb-saver mode is enabled.
• Front-Panel Operation: Press
(screen saver) softkey from the "System" menu.
130
and then select the Beep softkey
Issue a single beep immediately
Disable/enable beeper
and then select the Scrn Svr

Advertisement

Table of Contents
loading

Table of Contents