Table of Contents
Advertisement
3
Chapter 3 Features and Functions
Remote Interface Configuration
Web Password (LAN) You can set a password to control access to your
instrument via the Web Interface. The default is no password.
• Enter the password using the knob and cursor keys. Each character
must be a letter ("a" through "z").
• Use the knob to select each character.
• Use the cursor key to move to the next character.
• Use the
key to delete all characters to the right, starting at
the cursor position.
• Front panel operation: Press
LAN, then Modify Settings. The Password field appears. Enter the
desired password.
• There is no SCPI command to set the passwoard.
Current Configuration (LAN) Select the Currently Active Settings
display to view the MAC address and current LAN configuration.
• Front panel operation: Press
LAN, and then select Current Config. Use the "arrow" softkeys to
scroll the list.
• There is no SCPI command to display the configuration screen.
Note: This display reflects only the settings that are currently active. If
you have changed any LAN settings, you must first cycle the power to
activate the settings, then select Current Config. Also, this display is
static. It does not update information for events that have occurred after
the information is displayed. For example, if DHCP assigns an IP
address while the display is open, you will not see the new IP address
until you press the Refresh button.
Additional SCPI Configuration Commands (LAN) There are some
additional LAN configuration commands, not covered here, that are
covered in Chapter 4. See "Interface Configuration Commands" in
Chapter 4 for complete information about using SCPI commands for
LAN interface control.
142
and press the I/O softkey. Select
and press the I/O softkey. Select
Advertisement
Table of Contents
