Waveform Polarity - Agilent Technologies 33220A User Manual

• Remote Interface Operation:
OUTPut {OFF|ON}
The APPLy command overrides the current setting and automatically
enables the Output connector.

Waveform Polarity

In the normal mode (default), the waveform goes positive during the first
part of the cycle. In the inverted mode, the waveform goes negative
during the first part of the cycle.
• As shown in the examples below, the waveform is inverted relative to
the offset voltage. Any offset voltage present will remain unchanged
when the waveform is inverted.
Normal Inverted
No Offset Voltage
• When a waveform is inverted, the Sync signal associated with the
waveform is not inverted.
• Front-Panel Operation: Press
softkey. Then press the Normal softkey again to toggle between the
"Normal" and "Invert" selections.
• Remote Interface Operation:
OUTPut:POLarity {NORMal|INVerted}
Chapter 3 Features and Functions
Normal
0V
With Offset Voltage
and select the Output Setup
Output Configuration
Inverted
Offset
0V
67
3