Power Display - Siemens SCALANCE X-200 Operating Instructions Manual

1. Link down event on a monitored port.
2. Failure of one of the two redundant power supplies.
3. C-PLUG
4. Device startup, the LED is lit for approx. 20 seconds.
5. Device is in PROFINET mode:
6. Redundancy manager connected through.
7. Switchover of standby connection.
8. Maintenance request or maintenance requirement.
9. An internal fault was detected. Inform the maintenance personnel and, if necessary, send
10. A loop was detected by the loop detection.
11. No fault detected by the IE Switch X-200.
3.28.2

Power display

SCALANCE X-200
Operating Instructions, 12/2011, A5E00349864-19
Note
The following devices do not have a redundant power supply:
 SCALANCE X204 IRT PRO
 SCALANCE X202-2P IRT PRO
 SCALANCE X201-3P IRT PRO
– a) There is no connection to the controller
– b) There is a connection to the controller, there is also a configured diagnostic
interrupt, for example power fail interrupt, C-PLUG interrupt etc.
the device in for repair.
Product properties
3.28 Displays
121