Installing The Dlc Protocol; Working With The Primary Setup Tool - Siemens SCALANCE X-200 Operating Instructions Manual

Configuration / diagnostics using remote mechanisms
6.1 Assignment of an IP address
6.1.2.4

Installing the DLC protocol

Procedure
Follow the steps below to install the DLC protocol on a computer:
1. Select the menu Start > Settings > Control Panel > Network and Dial-up Connections.
2. Select the connection to your Ethernet communications module.
3. Open the Properties dialog using the context-sensitive menu (right mouse button).
4. Click the Install... button in the General tab
5. In the Network Component Type dialog, select Protocol and click the Add... button.
6. In the Network Protocol dialog box, select the vendor Microsoft.
7. In the Network Protocol dialog box, select the DLC protocol.
8. Close the Properties dialog box by clicking the OK button.
6.1.2.5

Working with the Primary Setup Tool

Language selection
After starting the Primary Setup Tool for the first time, a dialog box opens in which you set
the language for the program. You can also set the language separately in the Settings >
Language menu.
Selecting the network adapter
If there is more than one network adapter in your computer, you can open the Settings >
Network Adapter menu and specify which adapter is used by the Primary Setup Tool for
network access. This menu displays a maximum of four network adapters, however only
those for which the DLC protocol is activated are shown.
Browsing the Network
Before you assign IP addresses with the PST, you must first locate the configurable devices
in the network. It is only possible to search for devices if the forwarding of DCP frames is not
disabled.
Start this search with the steps outlined below:
● Select the Network > Browse menu command.
● Press the F5 function key.
● Click on the magnifier icon in the toolbar below the menu bar.
While the Primary Setup Tool browses the network, the Browse Network dialog is displayed
with a progress bar. On completion of the search, the Primary Setup Tool displays a list with
all the devices it has found in the left-hand pane.
150
Operating Instructions, 12/2011, A5E00349864-19
SCALANCE X-200