Siemens SCALANCE X-200 Operating Instructions Manual page 193

6.3 Configuration using Web Based Management (WBM) and Command Line Interface (CLI)
Settings for IE Switches X-200
Agent Enabled Features
E-Mail
Enables/disables E-mail functionality.
DHCP
Enables/disables the IE Switch X-200 searching for a DHCP server in the network when it
starts up and configuring its IP parameters according to the data supplied by this server.
TELNET
Enables/disables the availability of the IE Switch X-200 over TELNET.
SSH
Enables / disables the SSH protocol.
Agent IP Configuration
IP Address
The IP address of the IE Switch X-200. If you make a change here, the WBM loses the
connection to the IE Switch X-200. Enter the new address in the Internet browser to
reestablish the connection.
Subnet Mask
Here, you enter the subnet mask of the IE Switch X-200.
Default gateway
If the PC with the Internet browser is not in the same subnet as the IE Switch X-200, you
must enter the IP address of the default gateway here.
Syntax of the Command Line Interface
Table 6- 14
Command
info
ttimeout [E ¦ D ¦ Timeout]
mail [E ¦ D]
ping [-c number]
[-s length]
<IP address>
wbmtime [minutes]
SCALANCE X-200
Operating Instructions, 12/2011, A5E00349864-19
Agent Configuration - CLI\AGENT>
Description
Displays information on the agent settings.
Enable, disable or specify the TELNET
timeout. When specifying the value, a range of
60 to 600 seconds is possible.
Enables/disables the mailing function.
Sends a number of packets to the specified IP
address. If the parameters for number and
length are omitted, an IE switch sends ten
packets each with a length of 128 bytes.
Example:
ping -c 5 -s 256 192.168.1.1
Five packets with a length of 256 bytes are
sent to IP address 192.168.1.1.
Displays or specifies the time limit after which a
WBM connection is reset. A maximum value of
999 minutes can be set. The value 0 disables
the time limit.
Configuration / diagnostics using remote mechanisms
Comment
Administrator only.
Administrator only.
-
Administrator only.
193