Adjusting Zoom Scale And Position - LeCroy WaveSurfer MXs-B Getting Started Manual

G S
ETTING TARTED

Adjusting Zoom Scale and Position

U F P
SING RONT ANEL
It is easy to adjust your Zoom trace's scale and position. The WaveSurfer MXs-B
oscilloscope multiplexes the Vertical and Horizontal Front Panel controls to control
the zoom scale and position. This is done automatically after you have created the
zoom trace, and remains this way until you make a Channel, Math trace, or
Memory (reference waveform) active.
Panel Control
Delay
Timebase
Offset
Gain / Sensitivity
Push – Zero Delay
Push – Zero Offset
57
M
ANUAL
C
ONTROLS
If the Zoom trace you wish to adjust is not
active, touch the descriptor label once to
make it active.
Then, use the front panel horizontal and
vertical controls to adjust position and
scale. The operation of the knobs feels
natural. Use the following table as a guide.
Note: When a Zoom trace is active, no
channel buttons are lit. This indicates that a
Zoom trace may be currently active.
Zoom Control Action
Zooms horizontal position
Zooms horizontal scale
Zooms vertical position
Zooms vertical scale
Resets horizontal zoom to 10:1 scale, and resets to
default horizontal position
Resets vertical zoom to 1:1 scale, and resets to
default vertical position
WSMXs-B-GSM-E Rev A