Table of Contents
Advertisement
G
S
ETTING
TARTED
(To:) data entry field and use the pop-up keyboard to enter the recipient's e-mail
address.
You can send a test e-mail text message by touching the Send Test Mail button.
The test message reads "Test mail from [name of oscilloscope's e-mail address]."
Acquisition Status
For each general category of oscilloscope operation, you can view a summary of
your setups. These dialogs are not accessible through the Utilities dialog, but are
instead accessed from the menu bar drop-down menus. The categories are as
follows:
Vertical - select Channels Status . . . from drop-down menu
Timebase - select Acquisition Status . . . from drop-down menu
Trigger - select Acquisition Status . . . from drop-down menu
Math - select Math Status . . . from drop-down menu
In addition to these dialogs, summaries are also provided for XY setups, memory
(M1-M4) setups, and time stamps for sequence mode sampling.
R
C
EMOTE
ONTROL
Refer to the Remote Control Manual available at
information.
You can fully control your instrument remotely. The only actions for which you
must use the front panel controls are the powering up of the oscilloscope and the
setting of remote control addresses.
Standards
LeCroy remote control commands conform to the GPIB IEEE 488.2
may be considered an extension of the IEEE 488.1 standard.
Program Messages
You control the oscilloscope remotely using program messages that consist of one
or more commands or queries. The program messages you send from the external
controller to the WaveSurfer MXs-B oscilloscope must conform to precise format
structures. The oscilloscope executes all program messages sent in the correct
form, but ignores those with errors.
1
ANSI/IEEE Std. 488.2–1987, IEEE Standard Codes, Formats, Protocols, and Common
Commands. The Institute of Electrical and Electronics Engineers, Inc., 345 East 47th Street,
New York, NY 10017 USA
115
M
ANUAL
O
PERATION
www.lecroy.com
for more
1
standard. This
WSMXs-B-GSM-E Rev A
Advertisement
Table of Contents
