Passive Probe Compensation; Display Dashboard - LeCroy WaveSurfer MXs-B Getting Started Manual

Passive Probe Compensation

Passive probes must be compensated to flatten overshoot. This is
accomplished by means of a trimmer at the connector end of the probe.
1. Attach the connector end of your passive probe to any channel.
2. Connect the probe end to the CAL output connector at the front of
the oscilloscope. Ground the probe.
3. Adjust the trim pot at the connector end of the probe until the
square wave is as flat as possible.
D D
ISPLAY ASHBOARD
The WaveSurfer MXs-B oscilloscope's display contains valuable information about
the current settings of your Vertical (channel), Horizontal (Timebase), and Trigger
controls. In addition, there are many shortcuts that are available by using the
touch screen capability of your display to quickly access information or to open
dialogs.
WSMXs-B-GSM-E Rev A
W S
AVE URFER
MX -B O
S SCILLOSCOPE
26