Setting Up Pass/Fail Testing; Mask Testing Setup - LeCroy WaveSurfer MXs-B Getting Started Manual

Setting Up Pass/Fail Testing

Touch Analysis  Pass/Fail Analysis from the menu bar.
The following dialog is shown on the lower display area.
Select a Source for the mask test.
Touch either the Pass or Fail button to set the actions to occur upon your
waveform's passing or failing the test.
Touch the actions you want to occur: stop test, sound alarm, print result, emit
pulse, or save the waveform. If you want to have the results printed, be sure that
the oscilloscope is connected to a local or network printer. See Printing.
If you want to save your waveform automatically, touch the Save Setup. This exits
the current dialog and opens the Save Waveform dialog. Refer to the Saving and
Recalling Signals section for more details.

Mask Testing Setup

1. From the Test dialog (right side of the screen), choose one of the Test is True
when buttons:
A selection means (for example, if you select All In) the test is False if even a
single waveform falls outside the mask.
2. From Show Markers, choose whether or not to have mask violations
displayed.
WSMXs-B-GSM-E Rev A
W S
AVE URFER
MX -B O
S SCILLOSCOPE
92